Kemstrip-260
(Paint and Carbon Remover)

Product Description
Kemstrip-260 is specially formulated to remove hard carbon, varnish, baked paints by immersion method. It is highly recommended for the removal of such deposits from marine automotive, aircraft's and petrol engines Kemstrip-260 is non-flammable.

Product Specifications

Product Operating Data

Product Operating Procedure

Before dipping the components in Kemstrip-260 processing tank, they should be completely free from oil, grease or any other contamination by using our cold solvent cleaner or alkaline decreasing chemical. They components free from oil grease should be soaked completely in Kemstrip-260 solution and allow the components to remain the Kemstrip-260 liquid till the carbon deposits are completely dissolved or loosened. normally paints and lacquers are usaually softened in about 20 to 30 minutes while sludge of carbon/burnt oil will requires about 1-3. Hours soaking time. hard carbon deposits any require over night soaking time in Kemstrip-260 liquid Generally the soaking time will depend on the thickness and the composition of concentration. Remove the components after soaking In Kemstrip-260 and rinse with a jet of water to flush cut the loose deposits and dry in a steam or Hot air. Druign soaking components in Kemstrip-260 liquid, care should be taken to keep the upper layer of kemstrip-260 liquid minimum three inches above the bottom layer. The same may be maintained by adding water.

Kemstrip-260 is heavier than water and also insoluble in water. When Kemstrip-260 liquid is put into the tank (M.S.) the liquid will form two layer with water on top. Addition of water does not dilute the product to reduce its efficiency. kemstrip-260 practically does not corrode the steel, copper, Nickel, Magnesium, cadmium and chromium. However assemblies of dissimilar metals always raise the possibilities of galvanic corrosion.